Mauzil Our hybrid vehicles have set the standard for technology, efficiency and drivability. Install and torque the ten bolts. Install the pin into the hole of the case through the spring and pawl. Do not install the O-ring. See all 3 reviews.
|Published (Last):||24 January 2008|
|PDF File Size:||12.61 Mb|
|ePub File Size:||14.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
Merr If something wrong is found in a certain component group during assembly, inspect and repair this group immediately. Hybrid Warranty Our hybrid vehicles have set the standard for technology, efficiency and drivability. AT Remove the retaining spring.
This will help avoid confusion from similar-looking parts of different subassemblies being on your workbench at the same time. Install and torque the twelve bolts. RAV4 — Be careful that the check balls and oil strainer do not fall out. Install and torque the six bolts. AT Using a plastic hammer, tap out the differential left case. Connect the sensor connector. While compressing the piston return springs over the drum with hammer handles, install the snap ring into the groove.
Countless reasons to join. Using a plastic hammer, remove the right case retainer. Install the springs and pistons into the bores. Remove the twelve bolts. Install the snap ring. This repair manual covers Disassembly, Inspection and As. Remove the sun gear from the drum. Toe Contact Flank Contact Select an adjusting shim that will shift the driven pinion away from the ring gear. Previa — Place the cover into the bore. AT Check the distance between the direct clutch drum and the sun gear input drum.
Also See for Camry Repair manual — pages. Warranty and Maintenance Guides. Each bolt length mm, in. Install the oil seal ring to the piston. AT Remove the four O-rings from the solenoids. AT Remove the two differential side gears, two side thrust washers, differential spider, four differential pinions and four pinion washers from the differential left case. Genuine Toyota Parts are built to the highest standards of quality, durability and performance.
Coat the O-ring with ATF. Comments to this Manuals Your Name. Carefully observe all specifications for bolt tighten- ing torques. Install the B accumulator assembly. Every Toyota Certified Used Vehicle is put through a point quality insurance inspection, with each Used Hybrid tested to a point standard. Do not apply seal packing yet. Related Articles.
Manuals & Warranties
Nikasa AT Place the snap ring into the case so that end gap is installed into the groove. If the lining of the disc is exfoliated or discolored, or even a part of the printed numbers are de- faced, replace all discs. Apply the seal packing to the transaxle case and carrier cover as shown. Before assembly, make sure, again, that all component groups are assembled correctly. Countless reasons to join. Land Cruiser FJ60 — Install the pin through the oil pump mounting bolt hole.
Toyota 1991 Camry Repair Manual
1991 TOYOTA CAMRY OWNERS MANUAL PDF
Toyota Camry Owners Manual 1991