Packing: 1. Note: This glue is not recommended for use in pure oxygen or oxygen rich systems. This glue is highly flammable. Keep away from flames and other sources of ignition.
|Published (Last):||17 June 2016|
|PDF File Size:||5.7 Mb|
|ePub File Size:||3.21 Mb|
|Price:||Free* [*Free Regsitration Required]|
Do not store near oxidising agents or combustible materials. The product is light sensitve and accordingly, translucent containers should be kept in a dark place when not in use. Store product in the unopened container in a dry location. In some cases these aqueous washes can affect the cure and performance of the adhesive. Most surfaces may be bonded "as received" but contamination such as loose oxide layers or excessive oil may affect cure speed and bond strength.
Cleaning is recommended if maximum strength is required. Application Brush on the activator to one of the mating surfaces to be bonded.
Apply adhesive to other surface. Allow 1 to 5 minutes for solvent to evaporate. After the solvent evaporates, the active ingredients will appear wet, and will remain active for up to 2 hours after application. Contamination of the surface before bonding should be prevented. The activator will not dry and will remain active for up to 6 hours. Bond assembly should be completed within this time.
Where adhesive is applied onto an activated surface, assembly should be completed as quickly as possible within 15 seconds.
Henkel Loctite SF 7387
Loctite 383 Thermally Conductive Output Adhesive